Installation
Lumeta™ PowerPly™: Dramatic installation time and cost savings!
Lumeta™ PowerPly “Peel and Stick Solar”™ modules are simple to install, allowing a seamless application with most low slope roofing systems. This unique design means that there are no roof penetrations, no support rails, or any associated hardware needed to mount a conventional photovoltaic system. With Lumeta’s Building Integrated Photovoltaic solar modules installation time is reduced by 50%. Here’s how easy it is to install:
- Mark the array with chalk lines prior to installation
- Peel the release paper off of the butyl adhesive and lower module
- Adhere module to roof, applying firm pressure with a broom
- Repeat steps 1 through 3 until all modules are installed
- Line up battens or Oly Blocks between junction boxes and thread wire
- Connect the wires to the junction boxes
- Complete electrical assembly as you would any PV system